1. After the embroidery machine is in place, adjust the basic level and fix it with four foot screws. The machine is stable and cannot float.
2. Tighten the mounting screws of the wire rack so that they cannot float to avoid resonance.
3. Check the external power supply. Check whether the 380V power supply is in place and whether the ground wire is grounded.
4. Before starting the test run, remove all sundries on the table, check whether the embroidery confirmation lights are on, whether the color change confirmation lights (two) are on, whether the thread trimming and hooking proximity switch lights are on, and the parking spot light (100 °) ) Is it on. Clean the garbage during transportation, refuel, and rotate the main shaft with a special socket wrench, without jamming. After everything is normal, you can start commissioning.
5, the machine maintenance should always clean up dust, sand, thread and other garbage, no debris can be placed on the table, the mechanical transmission part according to the provisions of oil lubrication, oil should be separated from the engine oil and mechanical transmission part, white oil plus the shuttle and the Thread parts, silicone oil plus embroidery thread.
6, the working environment is best closed, maintain the specified temperature and humidity, dust and wind. The fan cannot be used to prevent messing up the embroidery thread.
7. When loading and unloading the bottom thread, the bobbin should rotate clockwise in the bobbin case. When the bobbin is taken out of the bobbin case, the bobbin case cannot be knocked on the bed or hard ground to prevent the bobbin case from deforming and causing the bottom line to go out smoothly.
8. Refueling method: Do not refuel too much at one time to prevent pollution of embroidery. It is best to use a special oiler to refuel and wipe the surface with tarpaulin.

www.cnjinlong.net